NASA officials scrubbed Wednesday’s attempt at 2:37 EDT to launch space shuttle Discovery after a slight leak was detected in a gaseous hydrogen (GH2) vent line. The vent line is at the intertank region of the external tank and is the overboard vent to the pad and the flare stack where the vented hydrogen is burned off. Image: A nearly full Moon sets as the space shuttle Discovery sits atop Launch pad 39A at the Kennedy Space Center in Cape Canaveral. Photo Credit: NASA/Bill Ingalls
The launch team is resetting to preserve the option of attempting a Thursday night liftoff at 8:54 p.m. EDT depending on what repairs are needed and what managers decide. The Mission Management Team is meeting at 5 p.m. today to discuss the issue.
LATE BREAKING INFO . . . Space shuttle Discovery’s launch to the International Space Station now is targeted for no earlier than March 15. NASA managers postponed Wednesday’s planned liftoff due to a leak associated with the gaseous hydrogen venting system outside the external fuel tank. The system is used to carry excess hydrogen safely away from the launch pad.
Liftoff on March 15 would be at 7:43 p.m. EDT. The exact launch date is dependent on the work necessary to repair the problem. Managers will meet Thursday at 4 p.m. to further assess the troubleshooting plan.
Here is NASA’s Fact Sheet for Gaseous Hydrogen Flow Control Valves
Gaseous Hydrogen (GH2) flow control valves are part of the main propulsion system on the space shuttle. There are three valves within the system, one dedicated to each of the shuttles main engines. The valve’s function is to regulate the flow of gaseous hydrogen from the main engines to the external fuel tank so the tank will maintain structural integrity and deliver liquid hydrogen to the engines at the correct pressure.
The GH2 flow control valve has two flow positions, high and low. During ascent, the valve moves between the two positions about 15 times. During ascent, the external fuel tank supplies the main engines with liquid oxygen and hydrogen propellants. As the engines consume propellant, the liquid level within each tank drops and causes an empty space above the liquid. To fill the void within the liquid hydrogen (LH2) tank, the engines turn LH2 into gaseous hydrogen and return this gas to the external tank. The role of the GH2 flow control valves is to regulate the amount of gaseous hydrogen that is returned to the tank.
For the shuttle engines to run correctly and for the hydrogen tank to maintain structural integrity, the LH2 tank pressure is regulated to 33 psi. For single flow control valve failures, the other two valves can compensate by moving to either the high or low flow position as required. In some cases, the other valves can not compensate and the tank pressure can reach 35 psi. In this event, a vent valve on the tank can open to relieve the pressure.
GH2 Flow Control Valve Poppet Failure During space shuttle Endeavour’s STS-126 mission in November 2008, flight controllers identified that GH2 was flowing from one of the shuttle’s engines at a higher than normal rate. To compensate, the other two gaseous hydrogen flow control valves reduced the amount of their flow and there were no issues during launch. After landing, the main propulsion system was inspected and engineers discovered the GH2 flow control valve poppet on the suspect line was cracked and a small piece was missing.
The poppet on the valve acts like a pop-up on a sprinkler to let the GH2 flow. The damaged valve was removed from Endeavour and shipped to the vender (Vacco) for disassembly. It was then sent to the Boeing Co. in Huntington Beach, California, where engineers determined that the crack was caused by fatigue.
The concerns are whether a failed poppet or poppets could cause:
- a rupture in the gaseous hydrogen line, resulting in loss of pressure to the external tank’s hydrogen tank. This could result in a main engine shutdown.
- an over pressurization of the hydrogen tank, forcing open a vent line that could expel hydrogen into an oxygen-filled area.
